Küchenprofi Easy Mode D'emploi page 6

G
Safety Instructions
1. lways wear heat-resistant gloves, if you come into contact with the metal
probe or the lead during the roasting process or once it has been completed,
because they are very hot. Please do not touch them at any time with your
bare hands! Risk of burning!
2. Keep the batteries, the lead and the metal probe away from children at all
times.
3. Clean the probe thoroughly before and after each use using hot water and a
mild detergent and dry it off. The roasting thermometer is not suitable for dish-
washers. Never immerse the appliance in water or other liquids as it is not
waterproof.
4. Never clean the body using caustic or abrasive cleaning agents which can
damage or destroy the body or the electronics.
5. Do not expose the device to the effects of quite heavy loads, dust, high
temperatures or high air humidity in order to avoid malfunctions and damage.
6. Do not make unauthorized changes to the components, under any
circumstances, as the guarantee will otherwise become invalid, and faults or
damage could occur.
7. Do not expose the device directly to the rays of the sun.
8. In order to avoid malfunctions, keep the device and the plug of the metal probe
dry at all times.
9. Never expose the metal probe to a naked flame. Pay attention that the metal
probe has no contact to the switched on grill or the hot side walls of the oven.
10. Do not use the metal probe if the temperature in the oven is over 250°C/482°F.
This would damage the lead.
11. Never use the metal probe in the microwave.
12. Please read through these instructions prior to using the device for the first time.
No liability is accepted for damage that occurs due to improper use.
Before first use
Remove the safety stripe from the battery compartment and close the cover. Now
the thermometer is ready for use.
Inserting or Changing Battery – the thermometer is working with 1 battery
If the display and the alarm signal are becoming weaker, insert or replace the
battery as follows:
• To open the battery compartment on the backside of the monitor slide the cover
with moderate pressure into the direction of the arrow.
• Insert 1 new 1.5V micro type (
the +/- markings. Only use alkaline batteries for a longer service life.
• Now put the cover back on and press until you can hear it engage.
Note: Remove the battery from the thermometer when it is not going to be used
for a longer time. lways remove exhausted battery from the appliance.
6
) battery. Please pay particular attention to