Metcal MFR-1100 Série Manuel D'utilisation page 4

Auto-Sleep and Auto Off Functions
To prolong tip life, MFR systems with a soldering hand-piece (MFR-H1-SC2, MFR-H2-
ST2) include an "Auto-Sleep Workstand" (WS1). When the hand-piece is placed into the
workstand, the "Auto-Sleep Workstand" immediately reduces power to the hand-piece.
All MFR systems have an "Auto Off" Function. The "Auto Off" Function will be engaged
when the hand-piece has been idle in the sleep stand for a period of two hours. The
channel LED indicator light will go from green to off. The "Auto Off" Function can be
reset by cycling the power switch.
LED Indications and Meaning
AC Power LED
· Green --- Power On
· Red ------ Ground Fault
· Off ------- Power Off
Channel LED
· Green --- On / Ready
· Red ------ Open connection: tip, connector
· Off ------- Channel not selected or channel is in Auto Off
(cycle the power switch to reset)
System Specifications
Ambient Operating Temperature
Maximum Enclosure Temperature
Input Line Voltage
Input Line Frequency
Power Consumption
MFR-1100
MFR-2200
Output Power Max.
Output Frequency
Power Cord 3-Wire
Dimensions w x d x h
MFR-1100
MFR-2200
Certification / Marking
Tip-to-Ground Potential
Tip-to-Ground Resistance
Idle Temperature Stability
Hand-piece Cable Length
Hand-piece Connector
Workstand Dimensions w x d x h
MFR-PS1100
10- 40°C
55°C
100- 240 VAC, grounded circuit
50/60 Hz
70 Watts max.
130 Watts max. (With both channels on)
60 Watts max. Per channel at 22°C ambient
temperature
450--480 KHz
183cm (18/3) SJT
90mm (3.5"), 297mm (8"), 142 mm (5.6")
122mm (4.8"), 200mm (8"), 152.5mm (6")
cTUVus, CE
<2mV
<2 ohms
± 1.1°C in still air
L=122cm (48"), burn proof, ESD safe
8-pin circular DIN
100 mm (4") x 200 mm (8") x 100 mm (4") max
4
MFR-PS2200