Cleaning, Care & Maintenance; Waste Tray - Buffalo DB170 Mode D'emploi

Masquer les pouces Voir aussi pour DB170:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
Cleaning, Care & Maintenance
If grease is permitted to accumulate, it will begin to carbonise into a hard substance that is extremely
difficult to remove. To prevent this, follow the cleaning steps below:
Always turn OFF the appliance and disconnect from the power supply before cleaning.
Allow the appliance to cool before cleaning, but for best results clean the plates when they are still
slightly warm.
Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
Take care when using scrapers to remove cooking residues as they can damage the cooking surface.
Dry thoroughly after cleaning.
A BUFFALO dealer or qualified technician should carry out repairs if required.
Warning: Do not use steel wool as it may leave shards that could Contaminate
food.

Waste tray

This appliance features a waste tray to collect any liquid or fats that run off during cooking.
At least once a day, remove and empty the waste tray before washing with warm, soapy water.
Warning: Do not remove the tray during or immediately after use as the contents will be
hot.
Troubleshooting
Fault
Appliance not
The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Appliance does
Faulty thermostat
not reach set
Faulty element
temperature
Appliance heats up
Indicator light has expired
but indicator light
does not come on
Power indicator
Faulty element
light comes on but
Faulty thermostat
appliance does not
heat up
Thermostat set incorrectly
Appliance slow to
Cooking surface not clean
heat up
Faulty element
No power
Thermal cut-out switch is
activated
DB170_ML_A5_v3 20210820.indb 5
DB170_ML_A5_v3 20210820.indb 5
Probable Cause
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified Technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
Check thermostat
Clean cooking surface as instructed
Call BUFFALO agent or qualified technician
Press re-set switch on rear of unit
UK
Solution
5
2021/8/20 16:24
2021/8/20 16:24

Publicité

Table des Matières
loading

Table des Matières