Standard Accessories; Applications; (110 V, 120 V, 127 V, 220 V, 230 V, 240 V); 520 W - Hitachi GP 2S2 Mode D'emploi

Wheels can be simply attached and detached by using
the two wrenches. (Fig. 2)
○ Do not tighten the collet chuck by inserting a shaft thinner
than the regular shaft diameter (6 mm) in the chuck or in an
empty condition. This practice will damage the collet chuck.
○ When installing a wheel with shaft, tighten the collet
chuck after applying a small quantity of spindle oil (or
sewing machine oil) to the tapered portion indicated in
Fig. 2.
5. Be sure to use the side handle to avoid the risk of severe
electrical shock.
6. Lightly press the wheel to the material to be ground. When
grinding materials, high-speed revolution is necessary.
Use a hand grinder with high-speed revolution, minimizing
the pressing force.
7. Dressing the wheel
After attaching a wheel, correct defl ection of the wheel
center by using a dresser. If the wheel center is eccentric,
not only precise fi nishing cannot be achieved but also
grinder vibration increases, lowering grinder accuracy
and durability.
A clogged or worn wheel will spoil the fi nishing surface or
lower grinding effi ciency. Occasionally dress the wheel
by applying the dresser.
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
GP2S2: Portable Grinder
Read all safety warnings and all instructions.
Always wear eye protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/
EC on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V Rated voltage
Alternating current
Power input
P
n
Rated speed
min Revolution or reciprocations per minute
-1
Switching ON
Switching OFF
Disconnect mains plug from electrical outlet
Warning
Class II tool

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package
contains the accessories listed in the below.
(1) Wrench (17 mm) ...........................................................1
(2) Wrench (12 mm) ...........................................................1
(3) Side handle (Not included by areas) .............................1
Standard accessories are subject to change without notice.

APPLICATIONS

○ Finishing of dies for press working, die casting and
moulding.
○ Finishing of thread cutting dies, tools and other small
parts.
○ Internal grinding of tools and machine parts.
SPECIFICATIONS
Voltage (by areas)*
Power input*
Rated speed*
Max. Wheel Diam.*
Collet chuck Capacity**
Weight (without cord)
* Be sure to check the nameplate on product as it is
subject to change by areas.
** This varies depending on the area.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.

MOUNTING AND OPERATION

Action
Assembling a wheel
Fixing the side handle
Changing a collet chuck
Switch operation
Replacing carbon brushes
Selecting accessories
5
English
(110 V, 120 V, 127 V, 220 V,
230 V, 240 V)

520 W

29000 min

-1
25 mm
6 mm
1.7 kg
Figure Page
2 126
3 126
4 127
5 127
6 127
― 128