Installation; Operation - Buffalo GF454 Mode D'emploi

Telephone Helpline: 0845 146 2887 (United Kingdom)

Installation

To install the Pie Warmer:
Remove the Pie Warmer from the packaging. Make sure that all protective plastic film and coatings are
1.
thoroughly removed from its surfaces.
Take the glass display panel and raise it at an angle into the upper track at the rear of the unit [Fig. 1].
2.
Once at the top of the track, position the bottom of the glass above the lower track [Fig. 2].
3.
Carefully lower the glass into the bottom track [Fig. 3].
4.
Fig. 1
Slide the wire racks into the bracket on the inner side of the Pie Warmer.
5.
Insert the two sliding door panels in the same manner as the display panel. Ensure the handles are
6.
located towards the outside edges of the appliance [Fig. 4].
Connect the plug to a suitable mains socket and turn on the power supply.
7.

Operation

Note: This appliance is for maintaining temperature only. It is NOT suitable for cooking
products or heating products from cold.
Add water (0.5L) to the water reservoir
1.
Set the thermostat to the desired temperature.
2.
The unit will cycle on and off to maintain the set temperature.
3.
The green indicator light and illuminated interior lamp shows when the unit is switched on
The red indicator light shows when the desired temperature has been reached.
Note: The appliance has a maximum temperature setting of 90°C.
UK
2