Vermeiren Albatros II Mode D'emploi page 14

2.3.2 Parking brakes
2.3.3 Foot plate
2.3.4 Leg support
L
WARNING: Risk of injury – Do not drop the leg support on the patient when
adjusting.
The leg supports can be adjusted in depth and 9 different heights.
Secure the two casters at the back of the
chassis by pressing the caster brake plates
down gently to their end stops with the tip of
your foot. To release the brake, push the brake
plate gently back up again with the front of your
foot until the casters are free.
The footplate
with the hooks
patient hoist. If it is required for a greater
stabilization of your feet you can use the special
footrests
The leg support
bar of the patient hoist
.
The leg support is meant to keep the legs
of the patient in the correct position and to
support the legs of the patient during stand
up.
1 = Bar for height adjustment
2 = Lever for depth adjustment
Table 2: Height adjustment leg support
Page 12
can be mounted or removed
to/from the chassis of the
with velcro straps for stabilization.
can be mounted on the
with the safety pin
Height from footplate
to top of leg support
690 mm
665 mm
640 mm
Do not use
Do not use
495 mm
470 mm
445 mm
420 mm
Albatros II
2012-09
Position
Hole 1
Hole 2
Hole 3
Hole 4
Hole 5
Hole 6
Hole 7
Hole 8
Hole 9