Saey H-60 S Notice D'installation Et D'utilisation page 53

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

General use
ATTENTION
There may be slight noises heard when lighting and cooling down. This is normal, and arises as a result of
the materials expanding.
Controlling combustion air
Combustion air is controlled by means of the left handle below the fire door.
Extreme left
Primary and secondary air fully
opened
Air supply open
Controlled combustion
Air supply closed
Fan control (SAEY INIGO)
The convection fan is controlled using a potentiometer. Turn the control fully to the right to heat up the room
more quickly. The flow rate can be reduced by turning the control to the left. The inset fire can also operate
without the fan, for which the fan is turned fully to the left.
Middle
Primary air closed, secondary air
opened
When lighting and filling, the primary and secondary air supply must be opened
to the maximum.
As soon as the fire is burning properly, the air supply can be reduced according
to the heating needs. Removing the air supply means that the wood will burn
less quickly. However, avoid smothering the fire. There should thus always be
bright flames.
The air supply may only be closed after the wood has burned out entirely. If
the inset fire is not being used, the air supply should always be closed.
Extreme left
Combustion air fully closed
53

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

H-70 sH-80 sHigh line h 60 sHigh line h 70 sHigh line h 80 s

Table des Matières