Replacing A Halogen Lamp - Bauknecht UXG7480VDS Instructions D'installation Et Guide D'utilisation Et D'entretien

To Remove Metal Grease Filters
1. Turn off fan and lights. Check that halogen lamp is cool.
Using the filter handles, pull filter towards the front of the grill
vent hood.
B
A
A. Filter handles
B. Front edge of filter
C. Back edge of filter
2. Pivot the back edge of the filter towards the back of the grill
vent hood.
3. Drop the front edge of the filter down and remove.
To Replace Metal Grease Filters
1. Insert the back edge filter into the filter opening.
2. Place the front edge up into place in the channel and firmly
press forward, depressing the springs while positioning the
back edge of the filter into place in the rear channel.
METAL GREASE TRAYS
Metal grease trays should be cleaned along with the metal grease
filters.
To Clean:
1. Remove metal grease filters. See "Metal Grease Filters"
section.
2. Remove grease trays from the back channel as shown in
following illustration. Clean and replace.
A
B
A. Grease tray
B. Back channel of grill vent hood
10
Step 1
Step 2
C
Step 3

Replacing a Halogen Lamp

Turn off the grill vent hood and allow the halogen lamp to cool.
Replace using the light bulb removal tool (provided).
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Using the light bulb removal tool, twist the halogen bulb
counterclockwise to remove.
3. Replace with a GU10, 120-volt, 35-watt, halogen lamp.
Check that the 2 pins on the light bulb are properly inserted in
the lamp holder socket holes.
4. Using the light bulb removal tool, replace halogen bulb by
twisting it clockwise into the socket.
5. Reconnect power.