Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Thank you for purchasing this SentrySafe gun safe product.
Please read this manual before using this product.
We are pleased that you have chosen one of our gun safes to protect your
firearms. You can be assured that your safe meets the California Department
of Justice standards for firearm safety. This manual will provide you with the
information you need to:
• unpack and set up your safe
• open the safe
• operate the lock
• take full advantage of your safe's special features.
Unbolting your gun safe from the shipping pallet
WARNING! UNBOLTING YOUR GUN SAFE FROM THE SHIPPING PALLET!
This is a two-person operation and should not be attempted without help. Before attempting to unbolt your new safe,
be certain someone is with you to help steady the safe while you work. Ensure the safe is standing upright on a flat, level surface. (Fig. A)
NOTE: Sentry Group is not responsible for any costs incurred for unit to be removed from pallet and installed in place.
Tools/equipment required
• Adjustable wrench, pliers, or 17 mm (11/16") socket wrench
• Hammer
B
Bolt-down instructions
To help provide maximum security, SentrySafe strongly recommends this safe be
bolted down. (Hardware supplied)
1. Select a suitable and convenient location for your safe. Set the safe in place and
use the holes provided in the bottom or back of the safe to mark the location
of the holes to be drilled in the floor or wall. It is not recommended to attempt
to bolt to both floor and wall. If bolting to a wall, please ensure that the safe is
resting firmly on the floor.
Note: Fire-Safe models cannot be bolted to the wall.
Remember to keep your combination a secret. Writing down a combination
and putting it in a desk drawer is like leaving your door key under the mat –
it invites entry.
Please retain this manual for your records. If you have any questions about
your gun safe, please visit our website at www.sentrysafe.com or call Sentry
Customer Service at 1-800-828-1438 or 1-585-381-4900. Customer Service
representatives are ready to assist you, 8 a.m. to 6 p.m., E.S.T., Monday - Friday.
1. Using a wrench or pliers, remove the nuts located under the X-cut in the carpet in the bottom of the
unit. (Fig. B)
NOTE: If the bolts turn when you begin to remove the nuts, reach between the slats of the
pallet and hold the bolts, by hand and/or with pliers, as you turn the nuts.
2. Once the nuts are removed, use a hammer to tap the bolts through the bottom of the safe.
3. Close door and put handle in locked position.
4. With your helper, slide safe to one edge of pallet. Tip the safe so that the edge moves to the floor.
C
(Fig. C)
5. Remove the pallet and stand the safe upright on the floor.
2. Move the safe away and drill holes of the appropriate diameter and depth for the
type of hardware and the mounting surface being used (2 each – bolts, washers
and masonry anchors).
3. Place the safe back over the holes and install the fasteners as required. If a water
resistant unit was purchased, rubberized washers are provided. Assure that the
area around the safe hole opening is clean using a damp cloth. Place the rubber
side of the washer facing down against the safe floor and install the fastener.
NOTE: SentrySafe is not responsible for any costs incurred if unit is to
be replaced.
3
A
Publicité
Table des Matières
