Electrum TSH912LX Mode D'emploi page 25

3. Assembling / Installation
WARNING
3.1. Installing the one-way valve.
Install the one-way flaps (Fig.3.2) in the exhaust hole (Fig.3.1) by
placing the ends in the holes (Fig.3.3).
3.2. Installation
If you have an outlet to the outside, your cooker hood can be
connected as on Fig.4. Use a flexible aluminum or plastic non-
flammable exhaust pipe suitable for cooker hood with a diameter of
150 mm.
• The cooker hood should be placed at a distance of 65~75cm above
the cooking surface for best effect (Fig.6).
• Once the height is set, install the hook (Fig.7.2) at the wall, using
appropriated plugs to your type of wall. We suggest a diameter from
6 to 8 mm. Refer to the instructions of the plug manufacturer in order
to use the correct screws.
• Place the exhaust pipe on the hood (Fig.8.1 & 8.2).
• Fix it, using a cable tie (Fig.9)
• Install the outside chimney bracket (Fig.10.2) on the outside chimney
(Fig.10.3) and ensure the inside chimney (Fig.10.1) slides smoothly.
• Put the hood on the hook (Fig.11.2).
• Put the chimney in position (Fig.12).
• Adjust the inside chimney and mark the position. Install the bracket
(Fig.7.1) on the marked position, then fix the inside chimney on the
bracket (Fig.13)
NOTE: if needed, longer chimney is available in option.
•
For safety reason, please use only the
same size of fixing or mounting screw
which are recommended in this
instruction manual.
•
Please use plugs appropriated to your
type of wall on which you want to
install the hood (refer to the
instructions of the plug manufacturer).