Rivacold BLOCKSYSTEM FA Mode D'emploi Et D'entretien page 26

E3 3 rd probe error (condenser temperature)
the associated controls are disabled
3 rd probe error (2nd evaporator temperature)
defrosting will end due to timeout
heat alarm (*)
adjustment is disabled
HP pressure switch alarm(*)
UK
adjustment is disabled
LP pressure switch alarm(*)
adjustment is disabled
E4 repeated heat alarm
adjustment is disabled permanently
E5 repeated HP pressure switch alarm
adjustment is disabled permanently
E6 repeated LP pressure switch alarm
adjustment is disabled permanently
LO low temperature alarm
HI high temperature alarm
EE data saving alarm
default parameters are loaded
Ec condenser cleaning alarm
Er network alarm (**)
Ed defrosting timeout alarm
Od door open timeout alarm
normal operation is enabled again
nx slave x alarm (on master only)
Ux slave x not connected (on master only)
the slave is not controlled
u0 master not connected (on slave only)
the slave is released from the network and operates
autonomously
dx slave x download failed(on master only)
(*) There is no reading on the display.
(**) Network alarms are where, subsequent to programming, the alarm command is communicated from the
master to all network devices, in the event that the alarm relay is triggered on the master itself
During operation, in specific conditions the following signals are displayed:
blink. no automatic when the
condition ceases
yes yes
yes no automatic when the
condition ceases
yes no automatic when the
condition ceases
yes no automatic when the
condition ceases
yes yes at switch on
yes yes at switch on
yes yes at switch on
yes yes automatic when the
condition ceases
yes yes automatic when the
condition ceases
yes yes at power-on or
after the parameter
has been stored to
memory
blink. no automatic when the
condition ceases
yes yes automatic when the
condition ceases
blink. no automatic at the
start of the next
defrost
blink. no automatic when the
condition ceases
yes progr. automatic when the
condition ceases
blink. no automatic when the
condition ceases
blink. no automatic when the
condition ceases
blink. no manual or
automatic when the
condition ceases
BLOCKSYSTEM FA-FT Pag. 26 REV. 04 10/07