Intenso 6513123 Notice D'utilisation page 9

Prior to installation:
Please observe the following safety information:
1. Remove your hard disk from the transport packaging only directly
before installation.
2. To avoid electrostatic discharge you should ground yourself.
Please touch the metal frame of the PC or a similar charge
eliminating material.
3. Always touch the hard disk on the sides. Do not touch any
components of the circuit board on the lower side of the hard
disk.
4. Do not drop or shake your hard disk and never put it down too
hard. This may damage the data carrier.
Note:
From time to time the S-ATA 1.5Gb/s-Hosts may not establish any
S-ATA 3.0 Gb/s interface connections due to problems with the
interface protocol. In this case, please contact the technical
support of the manufacturer of the hard disk.
Important information:
This product is not intended for commercial use, for medical or special
applications, where a failure of the product can cause injuries, fatalities or
substantial property damage.
Page 3 of 5 EN