Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

JS PRODUCTS | 6445 MONTESSOURI STREET, LAS VEGAS, NV 89113
(APR18)
Part No. 41568
Copyright © 2018 D
D
WALT
and the D
WALT Logo are trademarks of the D
®
E
E
Co., or an affiliate thereof and are used under license. The yellow/black color
scheme is a trademark for D
Definitions: Safety Guidelines
The definitions below describe the level of severity for each signal word. Please
read the manual and pay attention to these symbols.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury.
(Used without word) Indicates a safety related message.
NOTICE:
Indicates a practice not related to personal injury which, if not avoided,
may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR
ANY D
WALT TOOL, CALL US TOLL FREE AT: 1-844-377-8451
E
WARNING! Read and understand all instructions.
This manual contains important safety and operating
instructions.
Please read this manual carefully before
assembling this storage rack and save it for reference.
SAVE THESE INSTRUCTIONS
TECHNICAL SPECIFICATIONS
These feet are to be used with your D
DXST4500 or DXST4500-W industrial rack. The maximum weight
capacities of these racks cannot be exceeded.
DXSTA04MP
Copyright © 2018, D
WALT.
E
WALT Industrial Tool
E
WALT power tools & accessories.
E
WALT DSXT10000,
E
Technical Specifications
DXST10000 Total Capacity
DXST10000 Capacity per Shelf
DXST4500 and DXST4500-W Total
Capacity
DXST4500 and DXST4500-W
Capacity per Shelf
Adjustable Height
GENERAL SAFETY
• Keep work area clean and dry.
• Use correct/recommended tools for the job.
• Never leave tools unattended.
• Never force a part into place.
• Wear safety apparel.
• Wear safety glasses/goggles.
• Keep small parts away from children. Never leave a small children
unattended while assembling.
• Always use common sense – your personal safety is your responsibility.
SPECIFIC SAFETY FOR WALL MOUNT BRACKET
WARNING: Serious or fatal crushing injuries can occur from
shelving tipping over. To prevent this, the rack must be secured to a
wall, especially in earthquake-prone environments, where surfaces are
uneven, and where children and/or pets are present.
Parts List
No. Description
1
Mounting Plate
2
Upright Beam Support Bracket
3
Securing Tab
4
Securing Nut
WALT
E
5
Concrete Wedge Anchor
2
3
4
5
READ ALL INSTRUCTIONS
BEFORE YOU BEGIN:
• This manual contains important safety and assembly instructions.
• Read all instructions thoroughly and follow them with the use of
this product.
• Remove all components from the box, and lay them on the floor in
an orderly fashion.
• Wear eye protection.
10,000 lb (4,435.9 kg)
*when weight is evenly distributed
2,500 lb (1,133 kg)
*when weight is evenly distributed
4,500 lb (2,041.2 kg)
*when weight is evenly distributed
1,500 lb (680 kg)
*when weight is evenly distributed
7"
(17.78 cm)
Qty.
4
4
4
8
12
1

Publicité

Table des Matières
loading

Sommaire des Matières pour DeWalt DXSTA04MP

  • Page 1 Mounting Plate Upright Beam Support Bracket Securing Tab JS PRODUCTS | 6445 MONTESSOURI STREET, LAS VEGAS, NV 89113 Securing Nut (APR18) Part No. 41568 DXSTA04MP Copyright © 2018, D WALT Concrete Wedge Anchor Copyright © 2018 D WALT. WALT and the D...
  • Page 2 FIG. 4 FIG. 5 • Be cautious of sharp edges. • Ensure that the rack is level. BAD: • Keep this information for further reference. NEVER ALLOW STUD TO BE RECESSED LOOSEN/ Assembly Instructions (Fig. 1-3) IN TOP TIGHTEN SECURING SECURING NUTS NOTE: Having an assistant to help install the mounting plates to the...
  • Page 3: Liste Des Piéces

    N° Description Qté WALT et le logo D WALT sont des marques de commerce de DEWALT ® Industrial Tool Co. ou d’une société affiliée à cette dernière et sont utilisés sous Plaque de montage licence. L’agencement de couleurs jaune et noir est une marque de commerce Support de la poutre verticale des outlils électriques et accessorires D...
  • Page 4: Instructions De Mise De Niveau (Fig. 4-6)

    FIG. 6 FIG. 1 FIG. 2 SUPPORT DE LA POUTRE CORRECT : POUTRE LE GOUJON VERTICALE VERTICALE DOIT (PLAQUETTES VERS DÉPASSER LE HAUT) DE TROIS FILS OU PLUS PLAQUETTE DE FIXATION ÉCROU DE PLAQUE DE FIXATION MONTAGE GOUJON PLAQUE DE MONTAGE FIG.
  • Page 5: Lista De Piezas

    Lista de piezas JS PRODUCTS | 6445 MONTESSOURI STREET, LAS VEGAS, NV 89113 (APR18) Part No. 41568 DXSTA04MP Copyright © 2018, D WALT N.º Descripción Cant. WALT y el logotipo de D WALT son marcas comerciales de D WALT Industrial ®...
  • Page 6: Garantía Limitada De Un Año

    FIG. 1 FIG. 2 FIG. 6 MÉNSULA DEL SOPORTE DE BUENO: VIGA EL PERNO LA VIGA VERTICAL VERTICA PASANTE (LENGÜETAS HACIA ARRIBA) DEBE SOBRESALIR POR TRES O MÁS HILOS ASEGURAR LENGÜETA TUERCA DE PLACA DE SEGURIDAD MONTAJE PERNO PASANTE PLACA DE MONTAJE ADVERTENCIA: Asegúrese de que la estantería esté...

Table des Matières