Nightlight - Sunbeam Hospitality 1640-099 Mode D'emploi

For use on sheetrock or wood walls only.
The Sunbeam® Wall mount hair dryer is designed for installation on sheetrock
or wood walls only. To mount onto wall, be sure there are no hidden electrical
circuits or pipes in the mounting location.
1. Remove wall bracket from the unit.
2. Use the bracket as a template to mark the position of holes for drilling close
to electrical outlet, away from tub or sink.
3. Drill three 3/16 inch holes.
4. Insert the three anchor bushings by tapping lightly with a hammer until the
shoulder of the bushing rests against the wall.
5. Position wall bracket and tighten the two bottom screws first, then tighten
the top screw. (Anchor bushings and screws are provided for you).
6. match the slots on the back of the mounting base with the hooks on the
bracket.
7. Press base onto the hooks and slide down to insure secure mounting.
8. Plug the unit into the nearby electrical outlet (125 volt, 60 cycle AC only).
dANgER
– To reduce risk of electrocution, do not install where unit can fall
into tub or sink.
Wall
mounted
base

Nightlight

(HD3001 models only)
Nightlight On/Off
Dimmer Switch
(HD3001 models only)
MOUNTINg INSTRUCTIONS
Features of Your Hair dryer
Air Outlet
Cool Shot
3 Heat Setting
Switch
Off/Low/High
Air Switch
Test
button
Reset
button
button
Ionic
Indicator Light
(1640 & 1641 only)
4
Note: 1640,1641, and HD3001
has been designed to be
compatible with existing
1632-040/1632-020 hair
dryer brackets
BRACKET
Screw
Anchor
Bushing
Disposable
Lint Filter
Dual Wattage Switch
(model HD3001 only)
Cord Guard
Hinged Air
Intake Grill