Installation; Mounting Diagram - ASC PRESIDENT JFK II A+ Manuel D'utilisation

Welcome to the world of the new generation of radios. The
new PRESIDENT range gives you access to top performance
radios equipment. With the use of up-to-date technology,
which guarantees unprecedented quality, your PRESIDENT JFK
II A+ ASC is a new step in personal communication and is the
surest choice for the most demanding of professional radio
users. To ensure that you make the most of all its capacities,
we advise you to read carefully this manual before installing
and using your PRESIDENT JFK II A+ ASC.
A) INSTALLATION
1) WHERE AND HOW TO MOUNT YOUR MOBILE RADIO
a) You should choose the most appropriate setting from a simple and
practical point of view.
b) Your radio should not interfere with the driver or the passengers.
c) Remember to provide for the passing and protection of different
wires (e.g. power, antenna, accessory cabling) so that they do not
in any way interfere with the driving of the vehicle.

MOUNTING DIAGRAM

d) To install your equipment, use the cradle (1) and the self-tapping
screws [2] provided (drilling diameter 3.2 mm). Take care not to
damage the vehicle's electrical system while drilling the dash board.
e) Do not forget to insert the rubber joints [3] between the radio and
its support as these have a shock-absorbing effect which permits
gentle orientation and tightening of the set.
f) Choose where to place the microphone support and remember that
the microphone cord must stretch to the driver without interfering
with the controls of the vehicle.
- N.B. : As the transceiver has a frontal microphone socket, it can be
set into the dash board. In this case, you will need to add an exter-
nal loud speaker to improve the sound quality of communications
(connector EXT.SP situated on the back panel: E). Ask your dealer
for advice on mounting your radio.
5