Rotho 20450 Mode D'emploi page 10

Assembly instructions
Standard bathtub stand
item no. 20450
(images see fold-out page A2)
1. Connect the pairs of legs supplied to the
upper part of the bathtub stand. Please
note the numbers on the legs / upper
part.
2. Mount the leg with number 1 on the cor-
responding foot of the upper part (Fig-
ure A and B).
3. Ensure that the leg has securely clicked
into place (Figure C).
4. Mount the leg with number 2 on the cor-
responding foot of the upper part (Fig-
ure D).
5. Ensure that the leg has securely clicked
into place (Figure E).
6. After pressing the spring button (a),
move the sleeve (c) to the stopper (b)
(Figure E).
7. When the sleeve (c) has reached the cor-
rect position, it is locked in place by the
spring button (a) (Figure F).
8. Continue with the other side of the stand,
and perform the same steps for legs 3
and 4.
9. Set up the stand (Figure G and H).
10. The sleeve (c) of leg 2 needs to be pushed
upwards together with the sleeve of leg 4
in order to avoid damage to the product
(Figure I and K).
11. As soon as the spring buttons (a) on both
sides have clicked into place, the stand is
correctly assembled (Figure J and L).
6
EN
For the safety of your child
Always observe
the following safety notes!
Assembly instructions for
vertically adjustable bathtub
stand item no. 20451:
• The height of the foot section for each
pair of legs can be individually adjusted
in 3 stages. 95 cm, 100 cm and 105 cm.
The stand can thus be used to protect the
backs of persons with heights between
160 and 195 cm.
• Before you assemble the stand, set the
desired height for all legs. To do this,
press in the spring buttons and slide the
foot section until it clicks into place in the
desired position.
• Please ensure that all legs are the same
height.
• Follow steps 1. to 11. in the assembly in-
structions for the standard stand.