Care And Maintenance - Sennheiser HSP 4 Notice D'emploi

Attaching the cable to the cable grip
Attach the microphone cable to
f
the cable grip in the centre of
the neckband.
Note:
When attaching the thin cable, make
sure you also press the small cable
sleeve into the cable grip or the ca-
ble will fall out.

Care and maintenance

NOTICE
Liquids can damage the electronics of the device!
Liquids entering the housing of the device can cause a short-circuit and
damage the electronics.
Only use a soft, slightly damp cloth to clean the device.
f
Cleaning the sound inlet basket
To clean or replace the sound inlet basket, carefully pull it from the
f
capsule.
Moisten a small brush (bristle
f
brush or toothbrush) with isopro-
pyl alcohol.
Carefully brush off the sound inlet
f
basket.
Allow the sound inlet basket to air
f
dry for approx. 1 hour so that the
remaining isopropyl alcohol can
evaporate.
Reattach the sound inlet basket
f
to the capsule so that it locks into
place with an audible click. When
attaching the sound inlet basket,
make sure not to cover the sound
inlet.
HSP 4 | 21