Arcora ANIKO 30 FOAMTEC Manuel D'emploi Et Entretien page 15

ANIKO 30 FOAMTEC is made by the following parts:
 Machine body,
 foam/rinse pipe and vacuum tube,
 Foam/rinse accessory, to spray foam and rinse,
 pane wiper, accessory to vacuum hard floor,
 2 tanks of special sanitizing chemical SANEX FOAM, 1 bottle of ANTI-FOAM.
The machine body contains all the necessary devices for spraying foam, rinsing and
vacuuming:
 The air compressor and the compressed air tank, both located in the lower part,
 The lower tank, containing the water used to create foam and rinse,
 The upper tank, used to recovery the dirt sucked with the vacuum motor,
 The solution pump and the vacuum motor, situated inside the lower tank,
 The control panel for the pump, the motor and the compressor,
 The regulation panel, to pass from foam to rinse mode and to adjust the type of foam.
Foam / water
outlet valve
Structure of the machine
15
Control panel
Foam
regulation
panel
Compressor switch
FOAM/RINSE valve
Air pressure regulator
Air manometer