Appendix - Panasonic LKM-F933-1 Manuel D'utilisation

APPENDIX

Installation of the SuperDisk Device Driver for Windows 95 / 98
(When you operate the SuperDisk drive under Windows 95 version(Retail, OSR1), install
the Device Driver according to the below instruction.)
The SuperDisk drive must be installed into your host computer before installing this device
driver.
1. Turn on the personal computer and start Windows 95.
2. Set the SuperDisk driver disk for Windows 95/98 in the your drive(FD drive).
3. Open the Run... window from the Start menu.
4. Type "A:\SETUP.EXE" and press OK. (assumes that your drive is designed "A")
5. Follow the procedures displayed on the screen to install SuperDisk Device Driver.
Installation of the SuperDisk Device Driver for DOS/ Windows 3.1
The SuperDisk drive must be installed into your host computer, before installing this device
driver.
1. Turn the power of your personal computer on. If your system automatically loads
Windows, you must exit Windows and reach the DOS prompt C:\ .
This explanation assumes that your floppy drive is designed "A" and your hard disk drive
"C".
If, however, you have used other letters to designate your drives, please substitute
another appropriate letter.
2. Set the SuperDisk driver disk for DOS/ Windows 3.1 in the your drive(FD drive).
3. Type A: and press <Enter>.
The current drive changes to "A".
4. Type INSTALL and press <Enter>.
5. Type " 2 " and press <Enter> for selection of Installation menu.
The program data will then be transferred, and the CONFIG.SYS, and
AUTOEXEC.BAT, etc. will be changed.
Note: If you wish to designate the drive / directory where to install, select "1" of
Installation menu.
The completion message appears, and reach the DOS prompt.
6. Eject the driver disk from the your drive.
After the installation, store this disk in a safe place for future use.
7. To restart the system, press the reset button on your personal computer, or the following
keys:
Check that the device driver of this device has been installed during the start-up
procedure.
Every time DOS is started, the device driver of this device will be automatically installed.
A-8
Ctrl + Alt + Delete