Aqua Medic T Computer Mode D'emploi page 5

4. Adjusting the nominal value
A.) Press the „Temperature" button - a flashing indicator shows the actual adjusted nominal value.
B.) To change the value, either press the „+" or „-" button.
C.) Press the „Temperature" button again and the changed value is stored.
D.) Check the adjusted value:
- Press the „Temperature" button and the value is shown on the indicator.
- After four seconds, the measured value is indicated.
5. Switching from heater to cooler
This unit can be used to control either a heater or cooler. The settings can be changed as follows:
Remove power, after 10 seconds reconnect the power. After a few seconds, the display indicates the following:
- 111.1 for heater adjustments
- 000.0 for cooler adjustments
- Switching from cooler to heater:
Remove power, wait for 10 seconds, then press the „+" button. Connect the power and wait for the "111.1"
indication.
- Switching from heater to cooler:
Remove power, wait for 10 seconds, then press the „-" button. Connect the power and wait for the "000.0"
indication.
The adjustments are stored even by a power failure or removal from power source.
6. Calibration
This unit is delivered with a sensor. The calibration is permanent (no further calibration required). The unit only
has to be calibrated by replacing the sensor.
Remove power, wait for 10 seconds. While pushing the „Temperature" button connect the power. The software
version is displayed.
Release the „Temperature" button and the actual value can be corrected by pressing the „+"/"-" buttons (the
actual value should be controlled by a calibrated thermometer). Press the „Temperature" button again to save
the settings.
7. Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase on all material
and manufacturing defects of the device. Incidentally, the consumer has legal rights; these are not limited by
this warranty. This warranty does not cover user serviceable parts, due to normal wear & tear ie: impellers or
drive wheels etc. The original invoice or receipt is required as proof of purchase. During the warranty period,
we will repair the product for free by installing new or renewed parts. This warranty only covers material and
processing faults that occur when used as intended. It does not apply to damage caused by transport, improper
handling, incorrect installation, negligence, interference or repairs made by unauthorized persons. In case of
a fault with the unit during or after the warranty period, please contact your dealer. All further steps
are clarified between the dealer and AB Aqua Medic. All complaints and returns that are not sent to
us via specialist dealers cannot be processed. AB Aqua Medic is not liable for consequential damages
resulting from the use of any of our products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
5
- Technical changes reserved – 03/2019