Intended Use; Product Description; Installation And Connection - Quick QCC PLT 300 Mode D'installation Et D'emploi

CHARACTERISTICS / INSTALLATION
EN

INTENDED USE

• The QCC-PLT 300 is intended to be used to control colour and adjust the brightness of RGBW LED light sources; as well
as to control colour temperature, and adjust the brightness of dynamic white light sources (TW) and white single-colour
light sources.
• For fire-prevention reasons, install the QCC-PLT 300 in a ventilated, controlled-temperature environment, protected from
dust and humidity. Do not expose the dimmer pack to rain or humidity.
• Any other use should be considered improper and unpredictable.
F
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT.
IN CASE OF DOUBT, CONTACT YOUR DEALER OR QUICK
THE PACKAGE CONTAINS: QCC-PLT 300 - conditions of warranty - manual of installation and use.
TECHNICAL ELEMENTS AND DEFINITIONS
• Control device: in this specific manual, this is a user interface that generates the command signal (indicated in the
connection diagram with DMX 512 device).
• RGBW light sources: red, green, blue and white light source.
• Tunable White (TW) light sources: warm and cold white source light.
• White Single-colour Light light sources: warm white, natural white or cold white source.
• Command signal: in this specific manual, this is the electrical signal generated by a control device and which contains
the necessary information for the QCC-PLT 300.
• Control signal: in this specific manual, it is the electrical signal generated by the QCC-PLT 300 and which contains the
necessary information for the management of the RGBW system.

PRODUCT DESCRIPTION

The QCC-PLT 300 is an electronic device that is used to manage up to
32 QCC-DRV CH4 by using just two wires for supplying power and the
control signal.

INSTALLATION AND CONNECTION

• The QCC-PLT 300 can be easily mounted on a omega rail. Install the device on a vertical surface for better ventilation.
• The device must be placed in a suitably protected distribution board so that it can operate under the environmental
conditions indicated in the general specifications for use, and is not within reach of personnel who are not qualified.
• Always disconnect the supply voltage during installation and maintenance operations.
• Make the connections following the best practices, using cable of adequate type and size that are appropriate for the
environment conditions.
• Critically inspect your work immediately after installing or servicing the product.
• Turn on the power, MAKE SURE THE POLARITY IS RIGHT.
CUSTOMER SERVICE.
®
10
QCC-PLT 300 - REV002A
QUICK SPA