Thermostat Knob - purline CHD210A Manuel D'utilisation

OFF... Unit is OFF
FAN .... Fan only operation
LOW... Speed 1: 1000 watts
HIGH... Speed 2: 2000 watts
OPERATION:
1. Carefully remove your heater from the box and
bag.
2. Make sure that the heater is in the OFF position
before plugging the heater into a outlet.
3. Place the heater on a firm, level surface.
4. The power light will light up when initially
plugging the heater into an outlet.
5. For heater operation, set the Thermostat knob to
the maximum setting.
6. Set Power knob to the desired heat setting. Low
heat (1000W) and High heat (2000W) .
17
7. For fan-only operation, without any heat output,
turn Power knob to the fan setting represented by
FAN.
8. The Power light will remain lit during operation.
9. To disconnect heater, turn Power knob to the OFF
operation. Then remove the plug from the outlet.
WARNING: METAL MESH IS HOT WHEN
HEATER IS IN OPERATION

THERMOSTAT KNOB

Before setting the thermostat, allow heater to operate and
warm up the room (caution: the maximum capacity of
this heating is of 2000W. That means that according to
the variations in temperature and the volume of the room,
its control on the ambient temperature is limited). Set
thermostat knob to the maximum setting to start the
heater.
18
.