Overview; Front Panel; Rear Panel - INFOSEC UPS SYSTEM XP PRO Série Notice D'utilisation

5 OVERVIEW

5.1

Front Panel

1. Master Power Switch: Turn ON/OFF the UPS.
2. Line-On: AC Normal .
3. AVR Protection : When AVR is working under regulation mode, the light will turn on.
4. Backup mode: Battery in backup
5. Over Load: If the UPS is overloaded, this light will turn on and the alarm will beep.
6. UPS Cut-Off: Overload or cut-off
7. Battery Level: A bar graph showing how much of the UPS battery is being used.
8. Load Level: A bar graph showing how much of the UPS power is being used.
1
5.2

Rear Panel

1. AC line input socket: Connect power cable from the UPS to AC utility.
AC input fuse:
2. Contain the fuse to protect the UPS from over current from incoming AC utility.
3. Output receptacles: Connect power cables of computer equipment to these outlets.
4. Computer interface: This socket combines relay contact signals and RS-232
signals(Option) on DB9 connector.
5. Phone / Fax / Modem jack: Telecom transfer ports provide users to extend the
applications.
6. EXT. Battery: no available
7. UPS setup switch:
Dip1. Low load(below 50w) auto-shut OFF.
Low load auto-shut ON.
Dip2. DC-start ON.
DC-start OFF.
Dip3. Buzzer auto-reset OFF.
Buzzer auto-reset ON.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - France - www.infosec.fr
Hot Line : tél : +33(0)2 40 76 15 82 - fax : +33 (0)2 40 94 29 51- hotline@infosec.fr - 10 05 04 205 02
- -
5