Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Installation instructions
Before installation
Check that the input voltage indicated on the
characteristics plate is the same as the voltage
of the power outlet you are going to use.
Open the drawer and take out all the
accessories and remove the packing material.
Attention! The front surface of the warming
drawer may be wrapped in a protective film.
Before using the warming drawer for the first
time, remove this film carefully.
Make sure that the warming drawer is not
damaged in any way. Check that the drawer
opens and closes correctly. If you find any
damage, contact the Technical Assistance
Service.
Attention: the power socket should be easily
accessible after the warming drawer has
been installed.
The warming drawer should only be built-in in
combination with those appliances indicated by
the manufacturer. If it is fitted in combination
with other appliances, the guarantee is no
longer valid since it is impossible to
guarantee that the warming drawer will work
correctly.
Installation
To build-in the warming drawer in combination
with another appliance there must be a fixed,
interim shelf in the housing unit to support the
weight of both appliances.
The appliance to be combined with the warming
drawer will be placed directly on the latter
without any need to have a separating shelf.
To build-in the appliance which is combined with
the warming drawer, follow the instructions set
out in the respective instructions and fitting
booklet.
The
relevant
installation
indicated in mm in the diagrams shown at the
end of this booklet. Proceed as follows:
1. Place the warming drawer on the shelf and
slide it towards the interior of the niche in
12
dimensions
are
such a way that it is centred and
completely lined up with the front of the
unit.
2. Check that the warming drawer's frame is
properly levelled and is sitting evenly on
the shelf.
3. Open the drawer and fix the warming
drawer to the sides of the unit using the two
screws provided.
Electrical Connection
This appliance is equipped with a 6,5 ft (2.0m)
long power cord with a three-prong grounding
plug ready for connection to a 120 V, 15 A, 60
Hz power supply.
Further installation details are on the wiring
diagram.
The data necessary for the electrical connection
are described on the warming drawer's
characteristics plate and these must be
compatible with those of the power outlet you
are going to use.
WARNING: THE WARMING DRAWER MUST
BE CONNECTED TO EARTH.
The manufacturer and retailers do not accept
responsibility for any damage that may be
caused to people, animals or property if these
installation instructions are not observed.
Publicité
Chapitres
Table des Matières
