Unpacking; Requirements On The Installation Location; Prior To First Use; Operation - Graef FW 700 Mode D'emploi

Unpacking

Proceed as follows to unpack the unit:
• Pull the unit out of the cardboard box.
• Remove all packaging and possible stickers on the unit (do not remove the
name plate).

Requirements on the installation location

For safe and fault-free operation of the unit, the following has to observed during
installation:
• Use a firm, even, horizontal, non-slip and heat resistant surface with a sufficient
load capacity.
• Choose the location in such a way that children cannot reach moving parts (in
particular the blade) of the unit.
• The unit is not designed for installation in a wall or a built-in cupboard.
• Do not set up the unit in a hot, wet or moist environment.
• The power outlet must be easily accessible so that the power cable can be
quickly removed in case of emergency.

Prior to first use

Clean all individual parts thoroughly in order to remove potential production left-
overs. See "Cleaning".

Operation

NOTE
• The maximum duration of use is abt. 15 minutes. Subsequently let the unit
cool down at room temperature (approx. 1 hour).
IMPORTANT!
• Handle the blade with care as it may be sharp and may lead to injuries.
• The smooth side of the knife must point in direction of worm.
• Check to see that the opening is on the locating bolt in the housing.
• Turn on the control knob to "R" when food has got stuck in the worm. Hold
this button for approx. 5 seconds.
• Never put your fingers into the feed chute. Always use the stuffer.
• Remove or place the worm housing only at standstill and the connecting cable
removed.

Mincing machine attachment

• Take the requested perforated disc from the storage compartment.
24