BEGLEC JB SYSTEMS T3 Mode D'emploi page 6

ENGLISH
20. HEAD SHELL LOCKING NUT:
Attach the head shell by inserting it
into the front end of the tone arm
and then turn the locking nut
clockwise.
21. HEAD SHELL: Install the cartridge here. When installing a cartridge, refer to the
installation instructions supplied by the manufacturer of that cartridge. During
installation, attach the stylus protector to guard the stylus tip from damage.
SPECIFICATIONS
Motor:
Driving Method:
Starting Torque:
Starting Time:
Braking Time:
Speed selection:
Speed adjustment:
Wow & Flutter:
Tone arm type:
Tracking Error angle:
Cartridge weight:
Anti-skate range:
Power supply:
Power consumption:
Dimensions:
Weight :
JB SYSTEMS
Attach wires as follows:
White (L+) Left channel +
Blue (L-) Left channel -
Red (R+) Right channel +
Green (R-) Right channel -
8 pole, 3phase, brushless DC motor
Direct Drive
More than 1.8kgf / cm
less than 1sec second
less than 1sec second
1/3
33 ~ 45 ~ 78 RPM
+/-8% ~ +/-12% ~ +/-20%
less than 0,1% WRMS (JIS WTD)
Static balanced S-shaped tone arm.
Less than 3°
13~18g.
0~3g.
230V~ 50Hz.
10,5Watts
450 x 370 x 86mm (WxDxH)
8,5kg.
5/25
OPERATION MANUAL
T3 TURNTABLE