Controls And Functions - BEGLEC JB SYSTEMS T3 Mode D'emploi

ENGLISH

CONTROLS AND FUNCTIONS

1. START / STOP BUTTONS: Press one of these buttons to start or stop the platter.
2. PLATTER: The platter is equipped with a slip mat. This makes it easier to
manipulate the record for scratch performances.
3. MOTOR OFF BUTTON: Normally the platter stops while you press the start/stop
button (1). In this case the platter stops quite fast due to the electronic brake.
Press the "motor off" button if you want the platter to slow down more smoothly. As
long as the motor is switched off, the led of the button flashes. Press the button
again to switch the motor back on.
4. TARGET LIGHT: White led target light used to locate the exact place on your
record when used in a dark place.
5. SPEED SELECT BUTTONS: Used to select the desired speed.
• Press the "33" button to select the 33rpm speed.
• Press the "45" button to select the 45rpm speed.
• Press "33" and "45" buttons simultaneously to select the 78rpm speed.
6. REVERSE BUTTON: Press this button to reverse the platter rotation, press this
button again to end the reverse mode.
7. PITCH RANGE BUTTON: Press this button to adjust the range of the pitch slider.
• Press ones for +/-8% speed range. (normally used for beat mixing)
• Press again for +/-12% speed range.
• Press again for +/-20% speed range.
The next time you press this button you will switch again to +/-8% etc.
8. QUARTZ LOCK BUTTON: When the QUARTZ Button is pressed, the exact center
speed (0%) is enforced, even when the pitch slider is not in the middle. The blue
led in the center of the pitch slider (9) will be lit.
JB SYSTEMS 3/25
OPERATION MANUAL
T3 TURNTABLE