Clatronic UM 3644 Mode D'emploi page 33

WARNING:
• Always remove the plug before cleaning.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
• The blades on the knife block are very sharp. A risk of injury exists!
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The individual parts are not dishwasher-safe.
NOTE: Preliminary Cleaning
Fill the mixing vessel halfway with water. Operate the
appliance for approx. 10 seconds.
For thorough cleaning, please remove the mixing vessel.
Mixing Vessel, Lid and Measuring Cup
Clean these parts in a bowl of hot water. Then dry everything
before assembling the parts again.
Housing
Only a moderately moist cloth should be used for cleaning
the outside of the device.
UM3644_IM_new
Cleaning
Problem Possible cause
The device is The device is not
not working. connected to mains
power.
Wrong switch
setting.
The device is
fitted with a safety
switch.
This prevents the
motor from starting
up unintentionally.
The overheating
protection has been
activated. The motor
is too hot.
Troubleshooting
Remedy
Check the mains
connection.
Check the position
of the rotary switch.
Check that the
mixing vessel is
firmly in place.
1. Immediately turn
the switch to
the position "0".
Disconnect the
mains plug from
the wall socket.
2. Let the appliance
cool down for at
least 15 minutes
before switching
it on again.
09.05.17
33