Installation And Replacement Of The Active Carbon Filters - Qlima WR01 Manuel D'utilisation

Elimination of Packaging Materials and/or the Appliance
•
Placement of the WR01
•
•
IV

INSTALLATION AND REPLACEMENT OF THE ACTIVE CARBON FILTERS

Installation of the filter holder (see picture 3)
1.
2.
3.
4.
Smell may leak if the filter holder is not installed properly.
Replacing the filter
•
•
•
•
•
•
1.
2.
3.
4.
5.
Dispose of old filter
1.
2.
Picture 3
4
14
The packing is made from environmentally friendly materials and can be
thrown away in compliance with applicable local recycling provisions.
For proper operation, the WR01 must have sufficient air flow. Allow 8 cm
of space on both sides and back. Do not block the air vents. If they are bloc-
ked during operation, the WR01 may be overheated and cause malfunction.
Ifthetreater overheats, a thermal safety device will turn the WR01 off. The
WR01 cannot be operated until cooled down.
Do not place the WR01 near a hot damp surface such as gas or electric range,
or dish washer.
Remove stickers on the top AND bottom of the active carbon filter cylinders
(7).
Position the filter holder (3) on the back of the appliance (1) and connect
properly.
Fix the filter holder (3) with a firm push.
Position the cylinders (7) inside the holder (3)
Filters are consumables and they need to be replaced on a regular basis.
Filters generally last for 6months to one year depending on the use.
If smell emerges, you may wash the filter with running water at your sink.
Smell may leak if the filter holder is not installed properly.
You may repeat washing filters up to 3 times.
Replacement of filter is required if the smell emerges continuously. You may
purchase the filter in designated stores. Check at www.qlima.com
Unplug your appliance.
Remove the filter holder screw (6) by turning it counterclockwise.
Remove old filters (7) .
Remove all stickers from new active carbon cylinders top and bottom before
placing the new filters.
Place the new filters (7) and close the screw (6) by turning it clockwise.
Open the filter cap and empty the cylinder (7).
You may throw away the contents in regular trash bags.
Separate the cylinder as recyclable plastic waste.
6
7