Vimar SL24.T Guide Rapide page 9

SL24.T
Advanced calibration
(slow-down and pedestrian distance programmed by the installer)
Press
No. Step
push-button
1
- Preparation
2 PROG Procedure activation
3
51 Gate closing
4 - Gate opening
Setting the slow-down
5 51
point when opening
6 - Completion of opening
7 - Gate closing
Setting the slow-down
8 51
point when closing
9 - Complete closure
10 - Gate opening
Setting the pedestrian
11
51
distance
12 - Gate closing
13 - End of procedure
Remote control programming
Note: Remote control programming can only be done with the automatic gate system stationary
Step-by-step programming
No. Press push-button
1 MRX
2 Remote control push-button Slow flashing
3 -
Programming the second radio channel
No. Press push-button
1 MRX
2 Remote control push-button Fast flashing
3 -
Deleting a remote control
No. Press push-button
1 MRX
2 Remote control push-button Very fast flashing
3
-
Complete deletion of the receiver
No. Press push-button
1
-
2
MRX
3
-
After deleting all of the remote controls, the first one saved configures the control panel to accept only rolling-code or hard-coded remote
controls.
Description
Move the gate to approximately 1 metre from closing
Press the programming push-button PROG and hold it down; the PRG LED will start flashing slowly;
keep PROG pressed until the PRG LED flashes fast, and then release it
Press pushbutton 51: the motor closes at reduced speed up to the closing limit switch
The motor opens at normal speed
Press 51 to set the slow-down starting point when opening the gate
The gate continues until it reaches the opening limit switch
The motor closes at normal speed
Press 51 to set the slow-down starting point when closing the gate
The gate continues until it reaches the closing limit switch
The motor opens at normal speed
Press 51 to set the pedestrian opening space
The motor closes until the closing limit switch is reached
The PRG LED turns off. End of procedure
Signal
Description
PRG LED
Off Press the MRX push-button and hold it down until the green PRG LED starts flashing slowly
Press the remote control push-button that you want to save
Fixed 1 s Button of the saved remote control (new remote control)
3 flashes Memory full
Signal
Description
PRG LED
Off Press the MRX push-button and hold it down until the green PRG LED starts flashing fast
Press the remote control push-button that you want to save
Fixed 1 s Button of the saved remote control (new remote control)
3 flashes Memory full
Signal
Description
PRG LED
Off Press the MRX push-button and hold it down until the green PRG LED starts flashing very fast
Press the button on the remote control to delete
Fixed 1 s Deletion successful
PRG LED indica-
Description
tor
Off Remove power from the control panel and disconnect any batteries
Reapply power to the control panel without releasing the MRX button until the PRG LED turns
On continuously
off
Off Receiver deleted completely
EN
7