brennenstuhl Multi-Test MT 6 S/2 Notice D'utilisation page 8

013109 Multi-Test MT 6 S_2_013109 BA_Multi-Test MT 6_S 23.09.20
Operating Instructions
- If the battery compartment does not close securely,
do not use the product and keep it away from
children.
- Immediately consult a doctor if a battery is
swallowed or in any part of the body.
- Attach the supplied adhesive label with a warning in
your national language near the battery
compartment.
Inserting the Batteries
Remove the screw by turning counter-clockwise.
Insert the three button cells, negative pole first into the
battery compartment and then re-tighten the screw.
Battery type: 3 button cells 1.5V (392A, AG3, LR41,
V3GA, G3-A or similar).
Testing probe
Button
High intensity LED
Screw
Open
Close
ATTENTION:
With the exception of the batteries, never attempt to
remove any components from the device.
Do not use the device if the screw has been removed.
Tighten the screw completely (clockwise).
Prior to Use
Self Test
that the device is functioning correctly.
If this does not happen, stop using the device.
When the LED starts to weaken, the batteries need to
be replaced!
8
Before each use of the device, a self
test must be performed in order to
assure correct function. Just touch
the probe with one hand and the
screw on the device with the other.
The blinking of the LED indicates
MT 6 S/2