brennenstuhl Multi-Test MT 6 S/2 Notice D'utilisation page 10

013109 Multi-Test MT 6 S_2_013109 BA_Multi-Test MT 6_S 23.09.20
Operating Instructions
Conductivity test
WARNING! Make sure that there is no alternating
current or high voltage current!
tivity, the LED will blink. This function can be used to
test, e.g. fuses, light bulbs, etc.
Flashlight Function
Sample Applications
Test the function of lamps and fuses (continuity test)
Locating cable breaks (touch-free voltage test)
Testing of alternating current (voltage test)
Safety symbols
= Protection Class II (protective insulation)
= Read the operating instructions
ATTENTION! = Pay attention to the max. voltage
CAT.II = Overvoltage Category II
The integrated LED has been tested according to
IEC/EN 62471.
Technical Data:
Voltage test
Touch-free voltage test:
a) >=100 VAC (with single insulation)
b) 200-250 VAC
Polarity test
Continuity test
10
When testing, a finger of one hand
must touch the screw on the device.
At the same time, touch the testing
site with the probe and touch the
object opposite the testing site with
your free hand. If there is conduc-
Press the button to use the tester
as a flashlight.
70-250 VAC
3-36 VDC
0-5 MOhm
MT 6 S/2