Features; Assembly; Operation - Ryobi P343 Manuel D'utilisation

PRODUCT SPECIFICATIONS
Speed (OPM) ............................................................................................................................................ 10,000-20,000/min
Oscillation ................................................................................................................................................................3 degrees
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.

FEATURES

ASSEMBLY

WARNING:
Do not attempt to modify this product or create accesso-
ries or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Cutting wood, drywall, plastic
 Detailed sanding
 Using accessories identified as compatible with this
multi-tool
THERMAL PROTECTIVE DEVICE
If the motor becomes overheated, the LED will flash and the
motor will automatically cut off. If this happens, release the
switch trigger and let the motor cool.
NOTE: The tool will not operate until the motor cools.
LED LIGHT
The LED light, located on the front of the tool, illuminates
when the switch trigger is depressed.
WARNING:
Before installing the battery pack, always check to be
sure it is not in lock-on position (depress and release the
switch trigger). Failure to ensure that it is not locked-on
could result in accidental starting of the tool resulting in
possible serious injury. Do not lock the switch trigger in
applications where the tool may need to be suddenly
stopped.
5 — English