Kimpex 374790 Instructions D'assemblage page 7

"CLICK N GO 2" PLOW ATTACHMENT
Yamaha Rhino Yamaha Rhino Yamaha Rhino Yamaha Rhino
6) Install the pre-assembly of the attachment plate
and four (4) spacers
bend U-bolts installed in the previous step. Secure
B
with eight (8) M8-1.25 hex. nuts
parts. See Figure 6.
7) Assemble four (4) M8-1.25 x 25 mm carriage bolts
and one (1) M8-1.25 x 20 mm hex. bolt
V-plate using five (5) M8-1.25 hex. nuts
A
the first threads only, except for M8-1.25 x 20 mm
hex. bolt , which must be fully tightened. See
E
Figure 6.
Front of the
Fig. 6
8) Assemble the V-plate
by first aligning the rear carriage bolts, then the
front carriage bolts
C
Fig. 7
9) Once the M8-1.25 x 25 mm carriage bolts
inserted to the bottom of the oblong holes of the
attachment plate , tighten all bolts in place.
01
Position of the Push Frame Hook Assembly
Install the push frame hook assembly in Position 3. Refer
to the instructions of the push frame for the assembly
procedure.
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
28105 5 5 5 2 2 2 2 7 7 7 7 • A A A A - - - - 2810527 2810 2810527 • Printed in Canada
2810 2810 2810527 2810527
ASSEMBLY INSTRUCTIONS
with the 92.9 mm square
01
, then tighten all
D
on the
E
. Screw
D
vehicle
on the attachment plate
A
. See Figure 7.
are
C
02
C
01
374790
KIMPEX NO.
3