Kimpex 374790 Instructions D'assemblage page 6

"CLICK N GO 2" PLOW ATTACHMENT
Yamaha Rhino Yamaha Rhino Yamaha Rhino Yamaha Rhino
Plow Attachment Installation Procedure
1) Remove the three bolts and washers. Install the
attachment plate
02
mm bolts , the three (3) M6 flat washers
03
the three (3) spring washers
Fig. 1
2) Using the plate as a reference, mark the centre of
the eight (8) oblong holes as shown in Figure 2.
Fig. 2
3) Remove the attachment plate
Drill the skid plate of the vehicle using the provided
tool at locations shown in Step 2.
Fig. 3
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
28105 5 5 5 2 2 2 2 7 7 7 7 • A A A A - - - - 2810527 2810 2810527 • Printed in Canada
2810 2810 2810527 2810527
ASSEMBLY INSTRUCTIONS
using the three (3) M6 1.0 x 30
05
. See Figure 1.
04
Front of the
vehicle
installed in Step 1.
02
4) Pre-assemble the four (4) spacers
M8-1.25 x 25 mm carriage bolts
M8-1.25 hex. nuts
See Figure 4.
and
Fig. 4
5) Pass the four (4) 92.9 mm square bend U-bolts
the vehicle frame in holes previously drilled. See
Figure 5.
Fig. 5
KIMPEX NO.
using four (4)
01
and four (4)
C
. Tighten the first threads only.
D
D
02
01
C
374790
in
B
2