Tuner Operation; Preset Stations - Jensen Marine MS2013BT Guide D'installation Et D'operation

MS2013BT

TUNER OPERATION

17 12 11 13
19
3
16
1 4 15 2b
Select a Band
Press the BAND/SEARCH button (16) to change between three FM bands and two AM (MW)
bands.
Manual Tuning
Press the SEEK/TUNE/TRK |<< or >>| buttons (13, 14) to seek stations up/down step by step.
Auto Seek Tuning
Press and hold the SEEK/TUNE/TRK |<< or >>| buttons (13, 14) to automatically seek the next
or previous strong station.

Preset Stations

Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Press and hold a preset button (5-10) for two
seconds. The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (5-10) to select the corresponding stored
station.
2a 18 20
MS2013BT
14 5 6 7 8 9 10
Automatically Store / Preset Scan (AS/PS
Automatically Store
Select a band (if needed). Press and hold the AS/PS
seconds to automatically select six strong stations and store them in the current band. The new
stations replace any stations already stored in that band.
NOTE: During Auto Store (AS), the tuner will default to "Local" mode while scanning the
band initially. After scanning the entire band once, the unit will switch to "Distant" mode
for all subsequent Auto Store tuning.
Preset Scan
Select a band (if needed). Press the AS/PS
current band. The unit will pause for ten seconds at each preset station. Press AS/PS
to stop scanning when the desired station is reached.
7
)
button (15) for more than three
button (15) to scan stations stored in the
again