Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONNECTING AND CHARGING LIPO / LIFE PACKS
•
First connect the charger to the mains (230 V AC / 50 Hz).
•
Set the battery type (LiPo / LiFe) using the switch below charge outputs 1 and 2.
•
Connect the battery voltage sensor lead to the Equalizer, with the black wire (battery
pack negative terminal) at the position marked by the arrow (see wiring diagram).
•
Connect the battery to the appropriate charge output, taking care to maintain cor-
rect polarity (red = + / black = -).
•
If the connections are correct, the LED above the charge output lights up, and the charge
process starts. If the "POWER" LED flashes, a battery is connected incorrectly! If
this should happen, disconnect the battery and the mains lead, then start again.
•
Lithium batteries connected to output 1 and 2 are switched off automatically at the end of
the charge (CC-CV process), and the output LED flashes.
INTRODUCTION TO BATTERIES
Certain precautionary measures must be taken when working with batteries, in order
to prevent personal injury and property damage. You bear the responsibility when
using these batteries.
Nickel-Cadmium batteries (NC)
We recommend the following charge rates for NC batteries:
High-energy batteries: 1 - 2C; please observe the battery manufacturer's recommendations.
High-current batteries, 2 - 3C, up to 5C under extreme circumstances. Observe any maxi-
mum charge current information provided by the battery manufacturer. Check also that the
connectors and charge leads are suitable for the charge current you have selected.
NICKEL-METAL-HYDRIDE BATTERIES (NIMH)
We recommend the following charge rates for NiMH batteries:
High-energy batteries: 0.5 ... 1 C; please observe the battery manufacturer's recommendati-
ons.
High-current batteries: usually 1C, although many battery types can be charged at 1.5 ... 2C.
Observe the maximum charge currents stated by the battery manufacturer.
Operating Instructions
Power Peak ® UNI 7 EQ
Lithium Akku
+S3
+S2
+S1
-
-
Battery type select switch, LiPo / LiFe
12
# 30 8564
Publicité
Table des Matières
