DRAWBAR
Dump Handle
Bag arm Channels
Pivot rod
Height adjustment Handle
Knob
Drawbar
Drawbar offset Tube
How To use Your sweePer
CauTIon:
maximum towing speed is 6 m.p.h.
Driving too fast may cause damage to wheels
and bearings.
BrusH HeIGHT aDJusTmenT
To adjust sweeper brushes to best operating height,
loosen adjustment knob and lift up on height adjustment
lever to raise the brush, or push down on the lever to
lower the brush. See figure above. Best adjustment is
when the brush setting is 1/2" down into the grass. Always
mow the grass to an even height before sweeping.
DrawBar oFFseT
The drawbar can be attached to the center, left hand or
right hand set of holes in the drawbar offset tube.
oPeraTIon
(sweePer sHown In DumP PosITIon)
DUMP
HANDLE
DRAWBAR
OFFSET
TUBE
KNOB
HEIGHT ADJUSTMENT HANDLE
Permits dumping of hopper bag from driver's seat.
Connects the hopper bag to the sweeper housing.
Allows hopper bag to tilt forward to dump material.
Adjusts the operating height of the brushes.
Locks the height adjustment handle into a height adjustment hole.
Connects the sweeper to the towing vehicle. Adjusts for various height tractor hitches.
Allows drawbar to be offset from tractor.
PIVOT ROD
sweePInG sPeeD
Do not exceed 6 m.p.h. Try a starting speed of
approximately 3 m.p.h. (third gear on most tractors).
Adjust the sweeping speed according to conditions in
order to achieve best results.
DumPInG oF sweePer
Your sweeper can be dumped without getting off of the
rider or tractor. Unclip dump lever from pivot rod and
pull forward to empty the hopper. Always empty hopper
after each use.
CauTIon:
Excessive heat can damage the brushes and
hopper bag and could cause the bag and its
contents to burn.
9
BAG ARM
CHANNELS
Keep sweeper away from fire.