Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
25.
Insert the hopper support rods (7) into the hole
beneath the curved head bolt (26) in each upper
hopper tube. Flex and insert the rod into the hole in
the bottom rear hopper tubes as shown in figure 15.
noTe: The hopper support rods will flex about as much
as shown in figure 15 when they are assembled.
7
26.
Slide the pivot rod (2) through the flap in the bag's
windscreen first and then through the hole in each
upper hopper tube. See figure 16.
27.
Hammer a palnut (23) onto each end of the pivot rod .
See figure 16.
HInT: Place the bag on its side on a hard surface to
make installation of palnuts easier.
26
7
7
FIGure 15
2
23
FIGure 16
28.
Slide the handle grip (29) onto the end of the handle
tube (9) as shown in figure 17.
29.
Assemble the handle tube (9) to the dump tube (5)
and secure in place with a 1/4" x 1" curved head bolt
(26) and 1/4" nylock nut (24). See figure 17.
30.
Snap the dump handle clip (33) onto the pivot rod.
29
9
31.
To attach the hopper bag to the sweeper, slide the
pivot rod into the pivot rod retainers on the ends of
the bag arm channels. The channels go on the inside
of the bag tubes. See figure 18.
HInT: Temporarily loosen the plastic wing nuts (31) if
necessary to fit the channels inside the bag.
7
33
26
24
FIGure 17
31
FIGure 18
Publicité
Table des Matières
