Troubleshooting - Haier HWF05XCL Guide D'utilisation Et D'entretien

TROUBLESHOOTING

POSSIBLE
PROBLEM
Air Conditioner Power supply cord is not plugged
does not start or into an outlet.
operate
Power supply cord has tripped.
Unit is turned off.
A household fuse or circuit breaker
has blown.
Room does not The room is too hot.
feel cold enough
The temperature control may not
be set correctly.
Air flow is restricted.
Room feels too Temperature set too low.
cold
Air conditioner Air filter is dirty or restricted.
cycles on and off
Air flow is restricted.
too often
Outside air temperature is below
61˚F.
Outside temperature is very hot.
Water drips into Air conditioner is not properly
your house leveled.
Water drips Hot, humid weather.
outside your
house
Water collects in Humidity drains into cabinet base.
cabinet base
Air conditioner is Temperature outside is too low,
freezing up; ice below 61˚F.
forming on coil
POSSIBLE CAUSE
TROUBLESHOOTING
REMEDY
Plug unit into a mating grounded outlet.
Press and release RESET button on the power
supply cord.
Turn on unit using control panel.
Replace the fuse or reset the circuit breaker.
Allow time for the room to cool down when
you turn on the unit.
Adjust the temperature control on the
control panel.
Make sure the air discharge area is not
blocked.
Raise the set temperature.
Clean the air filter.
Make sure the air discharge area is not
blocked.
Do not operate the unit when the outside
temperature is below 61˚F.
Raise the FAN speed to the highest setting.
Tilt unit slightly from the front to the back.
Refer to Installation section. DO NOT drill a
hole in the cabinet base.
This is normal during days with high humidity.
This is normal during days with high humidity.
DO NOT drill a hole in the cabinet base.
To defrost coil, set to FAN OLNY SETTING.
ENGLISH
PAGE 19