Use - Qlima GH 8034 Manuel D'utilisation

Use only a correct low pressure regulator. Outlet pressure details: see rating label. Do not move the appliance when operating, shocks and
bumps may activate the safety device. Do not twist the flexible tubing or hose.
INSTALLATION OF THE COALS
The heater is provided including artificial coals.
RISK OF SEVERE INJURY: only use the provided artificial coals. NEVER use real coals. NEVER use any other flammable or inflammable materials
in the heater. Install the coals as per pic. 2.
The artificial coal pack is marked with 2 indicaters (inside the circles in pic. 3). Make sure the indicators are pointed forward, towards you.
Close the door completely after the coals are in position. Do not use the heater without the artificial coals.
pic. 2.

USE

The knobs for turning the gas heater ON are located on the upper part of the heater:
IMPORTANT:
Never push down button A for more than 40 seconds continuously.
A. Button to manual allow gas into the heater
B. Electronic ignition button
C. Thermostat
Button C is the cover of the battery compartment and can be screwed off. Install 1 x AAA-battery with "+" pole pointing upward.
Screw Button C back on.
1. Open the gascontainer valve (follow the instructions provided with the low-pressure regulator)
2. Allow the gas into the heater by pressing button "A", hold button "A" down for 20 seconds.
3. While holding "A" down: press button B for 1 second to create ignition sparks.
- If there are no sparks: check whether battery is full and check whether battery is fitted with '+' pointing upwards.
4. Blue color pilot flame should appear just below the coal pack.
- If blue color pilot flame does not appear: keep pushing the button down for another 20 seconds. Go to step iii
5. When blue color flame appears: keep pressing the button A for another 20 seconds, then release the button. The flames will now switch to
the coal pack.
6. Dial the thermostat to the high position = position 6
- The numbers on the dial are an indication for the wished room temperature
- When the room temperature reaches the temperature that belongs to (for example) dial number 4 than the heater will automatically
switch to lowest fire.
- When room temperature drops to the temperature that belongs to (for example) dial number 4 than the heater will automatically switch
to highest fire.
- Highest temperature position is 6. Lowest temperature position is 1.
1. 18/19 °C
2. 23/24 °C
3. 26/27 °C
4. 29/30 °C
5. 31/32 °C
6. 33/34 °C
If the heater does not want to ignite:
Check whether gas heater is full and give the gas cylinder a good shake (do not turn up side down!)
If sure that gas heater is full: Take the heater, your regulator and your gas cylinder to outside.
• Check and clean the filter of the regulator – remove all dirt and particles
Release a little bit of gas (outdoors!) from the gas container. This will clear present dirt particles to prevent
pic. 3.
4 4
37