Adjust The Height Of The Screen; Connecting The Cables; Transporting The I-See Touch; Tips For Usage - Rehan Electronics i-See Touch Manuel De L'utilisateur

Adjust the height of the screen

The height of the screen can be adjusted by fi rmly holding the screen on the left and right
side, and pulling the screen up or down to your preferred position.
EN

Connecting the cables

The only cable required to be connected is the power cable. Insert the power cable into the
back of the device and then into a wall socket.

Transporting the i-See Touch

If the device needs to be transported it is adviced to transport it in its original packaging in order
to avoid any potential damage to the device.

Tips for usage

• Avoid direct sunlight on the screen and tableau.
• Be careful when handling the moving parts of the reading table.
• The i-See Touch requires little or no maintenance. If you want to clean the exterior of
the device, only use a dry cloth. The use of aggressive cleaning products like alcohol,
acetone or other chemical substances is prohibited.
• Do not use the i-See Touch as a support for walking, sitting down or getting up.
• Switch off the device if you do not intend to use it.
• Ensure that the i-See Touch is placed in a well ventilated room.
• Place the i-See Touch on a stable surface to prevent it from falling.
• Only use your i-See Touch indoors. Do not expose the device to extreme temperature
fl uctuations or humidity. Do not place your i-See Touch next to a heat source.
• Only use the supplied cables and connect the adaptor to a wall socket outlet.
• Ensure that the i-See Touch is placed at a minimal distance of 10 cm / 4 inches from the
edge of the table.
16