● In the time display mode, press the DOWN key, and press UP to switch to the
"--:--" display, then press and hold the SET key for 3 seconds to turn off the
alarm function.
● The alarm will continue for one minute when the set time is reached.
Meanwhile, press any key to turn the alarm off and activate it again after
24 hours. Press the "SNZ" key to activate the snooze function and the alarm is
activated after 5 minutes.
● The snooze function can be used for 2 hours from the original alarm time. The
alarm mark on the display will flash when snooze is enabled.
5. SWITCHING BETWEEN 12/24 HOUR DISPLAY
In the time display mode, press and hold UP for 3 seconds to shift between 12 and
24 hour modes. When the 12 hour mode is set, the AM or PM mark will appear on
the display.
6. TURNING THE HOURLY ALARM ON/OFF
In the time display mode, press UP to turn on the hourly alarm function (marked
with "●"), and press UP again to turn off the hourly alarm function. In hourly alarm
mode, the clock beeps between 7:00 – 21:00 on the hour.
COMMENTS
1. If there is no operation within 30 seconds, the system will exit set-up and any
settings will be saved.
2. Press and hold SET for 3 seconds in any mode to exit set-up.
BATTERY CAUTION
1. Insert the batteries into the battery compartment according to the correct
polarity symbols (+/-).
2. Do not mix old and new batteries.
3. Do not throw batteries into fire.
4. Exhausted batteries are to be removed from the item.
5. When the product is not in use for long periods of time, remove the battery and
store in a cool, dry place to avoid leakage.
3