Installation Of The Wall Bracket - Michelin MVC 7.4V Notice D'utilisation

from the mains socket. Do not reconnect the mains adapter (4) with the
mains socket until the handheld vacuum cleaner's suction power has
noticeably decreased.

6. INSTALLATION OF THE WALL BRACKET

6.1. Danger – Electric shock!
Ensure that there are no power cables or other conduits or pipes in the
wall at the location where you intend to bore the holes for the wall bracket
(3). Drilling into a current-carrying electric cable can be potentially fatal!
a) Place the device plug (5) of the mains adapter (4) into the wall bracket (3)
as shown in the diagram. Secure the barrel plug 5 by turning it. (A)
b) Select a suitable installation location for the wall bracket (3): It must be
possible to remove the handheld vacuum cleaner easily and there must be
an accessible mains power socket for the mains adapter (4).
c) Drill two holes about 62 mm apart. Use the wall bracket (3) to mark the
holes, to ensure the correct spacing. The drill holes must be suitable for
5 mm wall plugs.
d) Push the wall plugs into the holes and then screw the wall bracket (3)
firmly into place using the screws.
e) You can place the nozzles on the accessories holder on the side.
f) Connect the mains adapter (4) to a mains power socket.
6.2. Charging
6.2.1. Note
a) Check to ensure that the on / off switch (6) has been pushed back (to the
position "0") before starting the charging process.
b) Place the handheld vacuum cleaner from above into the wall bracket (3)
so that the barrel plug (5) slips into the socket on the handheld vacuum
cleaner. The charge indicator lamp (7) lights up red and the charging
process begins (D).
c) Important: The charge indicator lamp (7) lights up green once the
handheld vacuum cleaner is charged enough to vacuum again. This does
not mean that all the batteries are completely charged. When the charge
indicator lamp (7) lights up green, the batteries are charged to around
80%.
8