Publicité
Les langues disponibles
Les langues disponibles
Fan for fastening on the aquarium edge
With the purchase of this unit, you have selected a top quality product. It has been specifically designed
for aquaristic purposes and has been tested by experts. With this unit, you are able to lower the
temperature of your aquarium water effectively.
1. Shipment
The arctic breeze consists of the following:
fan set with 2, 4 or 6 fans incl. clamp support for the aquarium edge
-
adjustable power pack
-
2. Safety instructions
-
When working in the aquarium, always disconnect all units from the power supply system before
putting your hands into the water. Connect all units to the mains via a residual current device with a
maximum residual current of 30 mA.
-
Suitable for indoor use only.
-
Protect the unit from moisture, splash and condensate.
-
Regularly clean the fans from dirt and lime deposits.
-
Not suitable as a toy for children.
3. Features:
12 V low voltage with an adjustable power pack (3 - 12 V). So the cooling power can be adapted to the
-
water temperature.
high capacity fans with 94,000 l/h (two-fold fan) to 282,000 l/h (6-fold fan)
-
power uptake only 0.7 – 2.8 W per fan
-
fan diametre 60 mm
-
air volume per fan 47,000 l/h with 12 V
-
Versions:
arctic breeze 2-pack
arctic breeze 4-pack
arctic breeze 6-pack
4. Working principle
The fan battery „arctic breeze "is attached on the aquarium edge in such a way that a constant air flow
wafts over the water surface. This leads to an increased evaporation. The evaporation cold arising in this
process cools the aquarium down by up to 4 ° Celsius.
5. Set-Up
The fan battery is put on the aquarium edge and fixed with the Allen screws. It should be fastened in such
a way that the fans blow air over the water surface - best in longitudinal sense. Due to the adjustable
power pack, the fan speed can be adjusted according to the cooling needs. Normally, it will be sufficient to
run the fans at a low level (3 – 4.5 V). Then, they are almost silent. At heat periods, the speed can be
increased to 12 V.
Available spare parts: Please refer to www.aqua-medic.de.
6. Maintenance
The fans are maintenance-free. However, they should be cleaned regularly, in particular of salt
depositions. The fans can be exchanged separately. To do so, an end cap has to be unscrewed. Then, the
protective grilles can be shoved out and the fans are accessible. Only exchange the faulty fan for an
original Aqua Medic fan. Only these are suitable for the installation to aquaria.
4
Operation Manual ENG
Number of fans:
2
4
6
Publicité
