Available Operations - HITEC X1RED Mode D'emploi

AC/DC-Input, Professional
Balance Charger, Discharger, Multicharger
Getting started

Available Operations

Depending on battery type, different operations will be available. This chart shows which operations are available for
the different types of batteries the X1 RED is capable of working with.
Battery Type Operation
CHARGE
DISCHARGE
LiPo
Lilon
STORAGE
LiFe
LiHV
FAST CHG
BAL CHARGE
CHARGE
AUTO CHG
NiMH
NiCd
DISCHARGE
RE-PEAK
CYCLE
CHARGE
Lead
Acid
Pb
DISCHARGE
Operation Description
The charge mode is for charging LiPo/LiFe/LiIon/LiHV batteries in normal mode.
This mode is for discharging LiPo/LiFe/LiIon/LiHV batteries.
This program is for charging or discharging a lithium battery which will not be
used again for an extended period of time.
A fast charge will result in a smaller than usual charging capacity but will reduce
the total charge time.
This mode is for balancing the voltage of LiPo battery cells while charging.
The charger will charge NiMH and NiCd batteries using the charge current set by
the user.
In this program, the charger detects the condition of the connected battery and
automatically charges the battery.
Note: You should set the upper limit of the charge current to avoid damage by
excessive charging current. The X1 RED may not be able to detect the charge
capacity of low resistance batteries.
This mode is for discharging a NiMH/NiCd battery
In re-peak charge mode, the charger can peak charge the battery once, twice, or
three times in a row automatically. This is good for confirming the battery is fully
charged and for checking how well the battery receives fast charges.
Automatically charges/discharges the battery up to 5 times.
This process can enhance the performance of NiMH/NiCd batteries.
This mode is for charging a Pb battery.
This mode is for discharging a Pb battery.
G
25