Installation; Installing The Sample Transport Assembly - Mettler Toledo DO307 Mode D'emploi

Installation

4. Installation
4.1

Installing the sample transport assembly

This unit is used to insert the sample into the heated zone of the sample tube.
Aluminium
insert
Glass boat
Tapered joint
Slider
6
Guide rod
Magnetic part
– Place an aluminium insert into the glass
boat.
– Insert the hook of the guide rod into the eye
of the glass boat.
– Fully slide back the slider towards the open-
ing of the tube (as illustrated).
– Carefully introduce the transport assembly
into the sample tube until the position of the
guide rod is fixed by the attraction of the
slider.
The boat is now positioned underneath the
tapered joint. You can introduce samples
through the tapered joint.
– Insert a silicon stopper (septum) or NS
stopper into the tapered joint.
– Close the tube with the screw cap as shown.
If you move the slider in towards the oven, the
glass boat will be slid into the heating zone of the
sample tube.
DO307
METTLER TOLEDO