Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Rated voltage
Rated power
Circuit breaker
RCD
Protection degree
Protection class
Pre-installation
> Install electrical connection according to the technical
drawing of the toilet.
DANGER
> Disconnect electrical components from the power supply
before the installation.
> Check that all components are de-energised.
> Prevent the power supply line from being switched on
accidentally by third parties.
> Ensure that there is no damage to the power supply cable.
> Lay a permanent power supply line which must be on a
separate circuit:
> Observe the position of the electrical connection
> Leave at least 800 mm (31½ ") of feed cable exposed
> Install circuit breaker
> If the product itself does not have electrical leakage
protection function, it must be installed in circuit where
there is leakage protection device installed.
> Means for disconnection must be incorporated in the
fixed wiring in accordance with the wiring rules and
having a contact separation in all poles that provide full
disconnection under overvoltage category III conditions.
6
57351_Mounting_SeWa_Starck f_US/20.06.1
120 V 60 Hz
1080 W
I
= min. 15 A
N
= 30 mA
I
N
IP X4
I
Risk of fatal electric shock
Cold water
Water pressure
Water hardness
Pre-installation
> Install water connection and water outlet according to the
technical drawring of the toilet.
Health risk and potential product
WARNING
damage!
> Supply the product with tap water from the main water
system only.
> Do not connect any waste water, grey water, industrial water,
sea water or other untreated or semi-treated water.
Product damage due to limescale
NOTICE
build-up
In regions with hard water, limescale build-up can impair the
performance of the product.
> Check the water quality in your region. Duravit recommends
the installation of a water softener with water hardness
≥ 14° dH (2.5 mmol/l).
DN15 (½ ")
0.07 – 0.75 MPa (10 – 109 psi)
max. 2.4 mmol/l (240 ppm)
Publicité
Table des Matières
