Domo DO918WK Mode D'emploi page 23

INSTALLATION
1. Remove all packaging materials and any promotional stickers.
2. Before connecting the appliance to the power net, leave it standing upright for about 8 hours. This
reduces the risk of any malfunctioning of the cooling system due to transportation.
3. Clean the inside of the wine cooler with lukewarm water and a soft cloth.
4. Place the appliance on a firm, steady surface, that is strong enough to carry a filled wine cooler. To
level the appliance, you can adjust the front support feet at the bottom of the appliance.
5. Do not place the appliance directly into sunlight or near heat sources. Direct sunlight could affect
the coating of the appliance and the proximity of heat sources may cause an increase of the energy
consumption. Extreme temperatures may also cause malfunctioning of the appliance.
6. Make sure that the air can circulate around the appliance. Therefore, leave a free space of at least 5
cm between the appliance and any other object.
7. The cord should not be exposed or left hanging loose to prevent possible accidents.
HANDLE
Attach the handle to the door with the supplied screws. Make sure the screws are at the bottom of the
handle. Screw it tight with a hex key.
USE
REVERSING THE DOOR
1. Make sure that the appliance is empty and disconnected from the power net.
2. Remove the cover plate (1) and the hinge pin (2) on top of the door.
3. Remove the screws (3), the plate of the switch (4), the door stop (5) and the hinge pin (6) at the
bottom of the door.
www.domo-elektro.be
1 2
4 5
3 6
23
DO918WK