Urmet 1092/711 Manuel De L'utilisateur page 5


Drill holes according to the type of ceiling (e.g. cement, wood) and the fasteners used.

Insert the wire with RJ45 connector needed for correct operation of the dome camera through
the hole in the bracket base and lead the wire out from the opposite side.

Connect the end of the wire to the RJ45 socket of the dome camera.

Fix the bracket to the ceiling using fastening devices (not included) suitable to the type of
ceiling and a load of approximately 5 kg. Be careful not to squeeze the wire between the
bracket and the ceiling (use the slot in the base of the bracket).

Fix the dome camera to the bracket using the three M4 screws included.

Tighten the lock screw on the upper part of the bracket.
Lock screw
DS1092-241
H 120 mm
L 130 mm
5